Latest HP Service Pack for ProLiant (SPP) Version 2014.02.0 contains a new Emulex OneConnect firmware 4.9.311.20. This is the new recommended firmware by HP for VMWare 5.x. Recommended drivers version for VMWare 5.0/5.1 is 4.9.288.0 and for VMWare 5.5 recommended driver is 10.0.725.2.
Section from release notes (link)
Resolved Issues from Firmware Version 4.6.247.5
BladeEngine Firmware
Enhancements
Added support for OCBB (Option Card Black Box – Active Health).
Added support for VC 4.10.
EDD 3.0 is enabled by default.
Incorporates signed UEFI 2.3.1 compatible drivers to support Secure Boot.
Adds support for multi-path Windows install to RAW disks.
Fixes
Resolves an issue that might result in link up/down when using ETHTOOL_OPTS.
Corrected an issue with traffic through a switch resulting in a lockup until downlink is disabled.
Resolves an issue of not discovering the iSCSI boot target when port 1 is configured as primary boot option through DHCP.
Known Issues
1. Firmware 4.2.401.6 is not compatible with Rhel 6.2×64 Inbox NIC driver
(version 4.1.255.11). In order to upgrade to Firmware 4.2.401.6, you must first
upgrade to Rhel 6.2×64 driver version 4.2.392.1 or later.
Symptom seen with 4.1.255.11 inbox driver: “TX hang in standard error as well as
/var/log/messages”
Download links
HP Service Pack for ProLiant (SPP) Version 2014.02.0
VMware ESXi5.0/5.1 Driver CD for Emulex OneConnect
VMware ESXi 5.1 Driver CD for Emulex OneConnect
VMware ESXi 5.5 Driver CD for Emulex OneConnect
HP March 2014 VMware FW and Software Recipe
Reblogged this on Sam's Stuff and commented:
Some good info on HP driver support for VMWare